Safety & Good Practices¶
Read this carefully before starting the exercises, to make sure you protect yourself & the equipment. Working with these circuits is safe as long as you follow these rules.
1. Short-circuiting¶
Never connect the + and – terminals of your batteries, without a resistor in between. A ‘short-circuit’ is a path of very low resistance, such as a wire. Because of the low resistance, a lot of current can flow (Ohm’s law!). This current will do things like heat up and melt stuff (like your battery holders) very quickly.
It’s good practice to wire up your circuit first, and double check connections, before connecting your batteries. Disconnect them again before changing your circuit.
When you are not using the batteries, either remove them from the battery holder or cover the ends of the wires of the batter holder in tape, to make sure they cannot touch.
2. EMG electrodes¶
These measurements involve attaching yourself to a circuit, so we have to be careful. A. Never use anything other than the recommended batteries to power your circuit. Do not connect your circuit to mains supply for power, ground, anything. B. Only connect the EMG electrodes to one arm. Don’t attach them to both arms or anywhere else. This is to avoid any currents from travelling across your heart. C. If you are using a laptop, disconnect your laptop charger & run from battery while the electrodes are attached to you. This is to prevent any surges from mains supply from backpropagating through your laptop, to you.
3. Amplifiers¶
These can be damaged if you provide too much voltage. The configurations we give you in the exercises are ok to use, but double-check you have them wired up correctly before attaching the batteries. If you want to try something new, check the data sheets for the amplifiers first.